2.5 Prints and Specifications

It is important that forging drawings be accurate and complete. The purchaser should indicate his first operation locating points, normally as a part of the drawing, and give prior notice should these points be changed.

It is equally important that the purchaser provide drawings of the finish machined part, or equivalent information. This will assist in the design of forging dies and tools, and in establishing effective inspection procedures.

Unless the purchaser's drawings and specifications direct otherwise, all dimensions are normally assumed to refer to lines intersecting at right angles to each other (commonly referred to as X, Y, and Z axes). Furthermore, unless the purchaser's drawings or specifications direct otherwise, circular shapes are normally assumed to be figures of revolution with a center on an axis, and all circular dimensions are normally shown as diameters.

Return to Table of Contents

array ( '#markup' => '

It is important that forging drawings be accurate and complete. The purchaser should indicate his first operation locating points, normally as a part of the drawing, and give prior notice should these points be changed.

It is equally important that the purchaser provide drawings of the finish machined part, or equivalent information. This will assist in the design of forging dies and tools, and in establishing effective inspection procedures.

Unless the purchaser\'s drawings and specifications direct otherwise, all dimensions are normally assumed to refer to lines intersecting at right angles to each other (commonly referred to as X, Y, and Z axes). Furthermore, unless the purchaser\'s drawings or specifications direct otherwise, circular shapes are normally assumed to be figures of revolution with a center on an axis, and all circular dimensions are normally shown as diameters.

Return to Table of Contents

', '#printed' => true, '#type' => 'markup', '#pre_render' => array ( 0 => 'drupal_pre_render_markup', 1 => 'ctools_dependent_pre_render', ), '#children' => '

It is important that forging drawings be accurate and complete. The purchaser should indicate his first operation locating points, normally as a part of the drawing, and give prior notice should these points be changed.

It is equally important that the purchaser provide drawings of the finish machined part, or equivalent information. This will assist in the design of forging dies and tools, and in establishing effective inspection procedures.

Unless the purchaser\'s drawings and specifications direct otherwise, all dimensions are normally assumed to refer to lines intersecting at right angles to each other (commonly referred to as X, Y, and Z axes). Furthermore, unless the purchaser\'s drawings or specifications direct otherwise, circular shapes are normally assumed to be figures of revolution with a center on an axis, and all circular dimensions are normally shown as diameters.

Return to Table of Contents

', )